I prefer to record them last but there are no rules. If you prefer to record them first, then do so.
To record vocals, make sure the place is quiet, shut the door, tell the people who live with you to be quiet, and do not record while your neighbor is drilling holes through his kitchen walls! Also, turn off your monitors and use a headset instead to avoid recording the playback with your microphone.
Condenser or dynamic microphones?
Dynamic microphones are solid, they don' need a power source, they can take heavy acoustic pressure (like a kick drum or a saxophone) and they are not too expensive. They are also less sensitive to surrounding noises than condenser microphones. The cons are they lack clarity in the high range, which renders takes less clear and defined than with condenser microphones. They can be used with Jack or XLR plugs.
Condenser microphones are much more responsive and accurate. Their high sensitivity is double-edged, because they will capture any noise when recording. The fans of your PC are noisy? Chances are this noise will be recorded. Sound comes out of your headset? It will be recorded by your condenser microphone. Children are loudly playing outside? You might get that too. However, some condenser microphones are called "cardioid", or "hyper cardioid", and they only record what comes from a specific direction, ignoring (more or less) other sound sources from other directions. On the contrary, omnidirectional microphones record what comes from anywhere. Not ideal for a home studio. Condenser microphones are also more fragile (don't knock them) and must be powered through a "phantom power", whose standard is 48 volts. This kind of power is either present on your audio interface and can be turned on and off with a button, or it will require the use of an external phantom power source that you will then connect to your audio interface. You have to use 3-pin XLR plugs that carry the phantom power current. Finally, condenser microphones are usually rather expensive, some of them cost several thousand euros (or dollars, or pounds), but only professional studios or rich amateurs can afford those. On the plus side, the sound you get with a condenser microphone will have the best quality.
Be cautious though, a good dynamic microphone is worth better than a bad condenser microphone. No big secret here, for microphones like for anything else, very low prices are rarely synonymous with good quality.
A few known and renowned microphone brands: AKG, Milab, Neumann, Rode, Sennheiser, Shure...
Some pieces of advice: buy a microphone stand and a pop filter (you can also make one yourself with wire and a piece of tights from your wife / girlfriend / mother / daughter / neighbor). The stand will prevent you from manually holding your microphone and thus produce handling noises. As for the pop filter, it prevents the air to hit the microphone and produce unwanted blowing sounds when you pronounce some letters such as "p" or "b".

Jack plug (left) and XLR (right)


No need to go on and on forever, recording is rather easy. As long as you pay attention to your recording levels and take care over your takes, you should get a satisfying result, good enough to finalize the song


Messages page # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
Gil
le 21/11/2010 à 12h44
Excellent site, merci pour toutes ces infos.
Marcus
le 20/11/2010 à 21h04
Super site, vraiment bravo, mais j'ai un problème, peut-être que je suis trop novice mais j'arrive pas à utiliser ce que je télécharge (fichier dll), pouvez-vous m'éclairer. Merci.
* * * * * * * * * * * * * * * * * * *
<em>D'abord, je précise que tous les téléchargements que je propose sont pour PC sous Windows uniquement, pas pour Mac ou Linux.
Ensuite, les fichiers DLL doivent être placés dans un répertoire "VST". Soit un répertoire déjà existant qui a été créé lorsque vous avez installé votre séquenceur, soit un répertoire que vous créez vous-même où vous le souhaitez. Dans tous les cas, il faudra indiquer dans les options de votre séquenceur quel est le(s) répertoire(s) où se trouvent vos VST.
Pour cela, ça dépend des séquenceurs. Dans Sonar (le séquenceur que j'utilise), il faut aller dans "Options", "Global", puis l'onglet "Plug-ins VST" : c'est là qu'on peut ajouter le(s) répertoire(s) où l'on range ses plugins.
Ensuite, si le séquenceur ne le fait pas automatiquement au démarrage, il faut lui indiquer de scanner les VST présents sur votre disque dur afin qu'ils soient pris en compte et ajoutés à la liste des plugins que vous pouvez utiliser dans vos projets. Là encore, la façon de faire dépend du séquenceur utilisé, mais je suppose que le principe est toujours le même.
Grebz</em>
JPR33
le 16/11/2010 à 17h50
Ton site est une mine d'informations !
Bravo
JC
le 15/11/2010 à 11h55
Super site, très instructif.
Bravo,
JC
crisdalsace
le 21/10/2010 à 16h54
Bravo et encore BRAVO.
Salutations,
Crisdalsace
